Répéteur d'écholink radio Ham AllStar Link 440 MHz 70 cm Tait TM-8105 outlet

This listing is for a complete repeater for the 70cm meter amateur radio band. Allstar and echo link work and frequencies anywhere between 440-470MHz are valid.

This node utilizes the top of the line Tait TM-8105 UHF transceiver which is configured to connect to the raspberry pi through a custom sound card interface built by me.

Please enter your programming configuration here when you are ready!

https://forms.gle/seR7AT2Kp1AnFvVm8 ( COPY AND PASTE)

Construction and configuration of the node will take up to 7 business days to ship out the node. Parts may be on order, and this could cause a delay in processing.

The frequency, AllStar Link configuration, and EchoLink configuration is included for free.

To setup,

1. Connect Raspberry pi to internet connection using ethernet

2. Power on node

3. Go to the frequency with your mobile or portable radio, and enjoy worldwide connections. If you put a good antenna on the node at a good location, the range can exceed 10 miles, and you will make use out of a very quiet radio band.

An instruction sheet for operation of the linking, DTMF commands, how to use AllStar Link and the repeater will be included.

INCLUDES:

2 Tested Tait 8105 Mobile Radios

USB interface hand built to interface audio and signalling connections to the raspberry pi.

Raspberry pi running AllStar link, and custom configured to your CallSign configuration

(Raspberry Pi case may vary from the one pictured, the case pictured is what was on hand when taking photos)

Mini UHF to SO-239 so you can plug in a PL259 based antenna.

Raspberry pi power supply

Please submit programming info shortly after you pay, so I know what to put in your radio.

Each Radio is individually tested and in spec to:

TX Power: 5 to 40 WATTS

RX Sensitivity: -122dBm Squelch

Frequency Error: <0.05KHz

w0sky981 at gmail